The distance between the TD-units. It is measured and entered by the operator, in millimeters or inch, depending on system setup.
The distance between the TD-M and the coupling gap. Automatically set to half the A measure, but can be altered if necessary.
The live value from the TD-S unit. Comparable to dial indicator value.
The live value from the TD-M unit. Comparable to dial indicator value.
The horizontal angular error expressed in mm/100mm or mils/inch.
The vertical paralell/offset error expressed in mm or mils.
Starts the shaft alignment program using the result from this measurement as pre-entered offset values.
Opens Application setup menu.
Saves the measurement result to the memory.
Print out the currently displayed screen on the connected printer.
Exits the program.
Connector for TD-unit and/or laser transmitter.
Battery low indicator.
Turn on the system.
Operation indicator.
