Place the mouse over the control panel icons and detailed information will be displayed below. Click on any icon to SEE the results screen for the selected program!

Shaft alignment of horizontally mounted machines.
Click now for details.

Measurement of dynamic movements such as offline to running machine movements ( OL2R).
Click now for details.

Shaft alignment of vertically mounted machines.
Click now for details.

Shaft alignment of offset mounted machines / cardan shafts.
Click now for details.

Shaft alignment of drive trains / machine trains with up to five units.
Click now for details.

Measurement of straightness in one axis.
Click now for details.

Measurement of straightness in two axes.
Click now for details.

Measurement of flatness.
Click now for details.

Measurement of roll parallelism.
Click now for details.

Receiver display. Shows the values from connected receivers. The values can be treated and filtered.

Real time data transfer. Program that sends the receiver values to the display unit's serial port.

Memory manager. Program for reviewing, labeling, printing, export and deletion of memory content.
Click now for details.

System setup. Setting of system wide parameters such as measurement units, auto-off time etc.

System voltage meter.

Decrease screen contrast.

Increase screen contrast.

Turns on/off the screen backlight.

Turns off the system.

Connector for receivers and transmitters

Voltage ok/low indicator (green/red)

Turns on/resumes the system.

Operating indicator.